Supervisor Functions

This section describes each function that’s available in the <supervisor_functions> section. When enabled, you can access these functions by tapping the Supervisor button to open the Supervisor Mode screen.

Each supervisor function outlined below contains the following attributes:

• key: The order in which functions are shown on the screen. The functions are shown in the following order:
• 
• For example, to specify that the Start Shift button is shown in the top left corner, assign it to the F1 key. Similarly, to place the Shift Override button at the bottom right corner, assign it to the F10 key.
• If necessary, you can configure the clock to show two pages of buttons. Functions assigned keys F1 - F10 are shown on the first page, and functions assigned keys F11 - F20 are shown on the second page.
• Note: Although you can configure ten buttons per page, a maximum of eight is recommended to ensure that the text associated with buttons is shown correctly in all languages.
• bio_off: Determines if biometric verification is required for the function, for clocks that support biometrics. Enter bio_off="yes" to bypass biometric validation for a function, or enter bio_off="no" to require biometric validation for a function.

Supervisor Mode functions

Button	Function
	super_in Override employees’ start shift clock entries.
	super_out Override employees’ end shift clock entries.
	super_start_meal Override employees’ start meal clock entries.
	super_end_meal Override employees’ end meal clock entries.
	super_start_break Override employees’ star break clock entries.
	super_end_break Override employees’ end break clock entries.
	shift_override Override entire shifts for employees.
	super_bio_menu Enroll employees for biometric verification and maintain biometric templates.
	super_enroll_picture Enroll employees for picture capture and maintain picture templates.
	enroll_raw_badge Enroll employee badges.
	schedule_transfer Override schedule transfers for employees.
	reset_pin Reset employee PINs.